27
Fig. 27—Control Settings at Start up
Remote Control Operation (cont.)
Fig. 26—LCD Screen
1.
TEMP Temperature indication.
2.
DISPLAY Indicates CURRENT room temperature.
3. FLAME Indicates burner/valve in operation.
4.
A:
5.
M:
6. SET
After batteries are installed, press any button and
the screen lights up and the room temperature is
displayed in °F , the control is in manual mode and
the battery level is displayed.
Manual Function (see Fig. 28):
To operate the remote system in the MANUAL MODE,
do the following:
ON OPERATION
Press the “ON” button and the heater flame comes on.
The display screen shows “ON” for three (3) seconds, the
display shows the room temperature, and the flame
icon.
OFF OPERATION
Press the “OFF” button and the heater flame shuts off.
The display screen shows “OFF" for three (3) seconds,
display shows the room temperature, and the flame
icon is off.
Screen while
pressing the
ON key
Screen while
pressing the
OFF key
Screen after
the 3-Second
Default
Screen after
the 3-Second
Default
Fig. 28—Manual Function
7
4 5
6
1
2
3
Thermostat function.
Manual function.
Remote control battery display
Temperature in degrees F or C.
7.
°C to °F
Control Settings at Start up (see Fig. 27):
The factory setting for temperature is °F. To change
this setting to °C Press the ON and OFF buttons
on the remote/transmitter at the same time. Follow
this same procedure to change from °C back to °F.
Setting °F/°C Scale
Vent-Free Gas Fireplace User’s Manual
To Next Page
Loading...
