32
Care and Maintenance
BURNER FLAME PATTERN
Figure 34 shows a correct burner flame pattern. Figure 35 shows an incorrect burner flame pattern.
The incorrect burner flame pattern shows sporadic, irregular flame tipping. The flame should not be dark
or have an orange/reddish tinge. NOTE: When using the heater the first time, the flame will be orange for
approximately one hour. If the burner flame pattern is incorrect, as shown in Figure 35, do the following:
• Turn the heater off (see TO TURN OFF GAS TO THE HEATER, pages 24).
• See the TROUBLESHOOTING GUIDE, page 34.
BURNER ORIFICE HOLDER AND PILOT AIR INLET HOLE
The primary air inlet holes allow the right amount of air to mix with the gas, which creates a clean burning
flam . Keep these holes clear of lint, dirt, dust, pet hair, and other debris. Before every heating season, clean
these holes—blocked air holes create soot. During operation, the heater should be cleaned at least every
three (3) months. A qualified service person should inspect the heater yearly.
Keep the burner tube and pilot assembly clean and free of dirt and other debris. Use compressed air of 30 PSI
or less to clean these parts. If using compressed air in a can, follow the directions on the can exactly. You may
damage the pilot assembly if the directions are not followed exactly.
Fig. 34—Correct Burner Flame Pattern
Fig. 35—Incorrect Burner Flame Pattern
Failure to keep the primary air opening(s) of the burner(s) clean may result in sooting
and property damage.
WARNING
You must keep the control areas, burner, and circulating air passageways of the heater
clean. Inspect these areas before using the heater. Have a qualified service person
inspect the heater every year. Excessive lint from carpeting, bedding material, pet hair, etc. may require
that the heater be cleaned more frequently.
CAUTION
Vent-Free Gas Fireplace User’s Manual
WARNING
Turn off the heater and let cool before servicing.
To Next Page
Loading...
