31
Remote Control Operation (cont.)
TROUBLESHOOTING
Any problems with the log set may be a result of the log set malfunctioning, or it may be due to the
remote system malfunctioning. First, review the manual to make sure all connections are properly made.
Then check the remote system in the following ways:
• Ensure the batteries are correctly placed in the receiver. If a battery is inserted incorrectly, the remote
system will not operate correctly.
• Check the battery in the remote/transmitter to ensure the contacts are touching the positive
(+) and negative (-) ends of the battery. You can bend in the metal contacts for a tighter fit.
• Be sure the receiver and remote/transmitter are within a 20-25 foot range of one another.
•
Do not allow receiver to exceed 130°F. Battery life is shortened when exposed to temperatures above 115°F.
• If the receiver is installed in such a way that it’s tightly enclosed in metal, the operating distance will
be shortened.
• Do not use rechargeable batteries—they do not supply enough power.
SPECIFICATIONS
Remote/Transmitter Batteries: (2) 1.5V AAA
Receiver Batteries: (4) 6V AA 1.5 Alkaline batteries
FCC REQUIREMENTS
THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY
UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER’S
AUTHORITY TO OPERATE THE EQUIPMENT.
Operating Frequency: 303.8 MHZ
FCC ID No.: Remote/Transmitter - 2ATZEFC20201 ; Receiver - 2ATZEFC20202
Remote/Transmitter Wall Clip (see Fig. 33):
You can hang the remote/transmitter on a wall using the
provided clip. If installing on a solid wood wall, drill 1/8" pilot
holes and use the provided screws. If installing on a plaster/
wallboard wall, first drill two 1/4" holes into the wall. Then, with a
hammer, tap in the two plastic wall anchors so that they are flush
with the wall. Then install the clip with the provided screws.
Battery Life:
Replace the batteries regularly. If the remote/transmitter no
longer functions at a distance it previously did or the remote
receiver does not function at all, check the batteries. The receiver
batters
should always provide a combined output voltage of at
least 5.5 volts. The hand-held remote/transmitter should
operate with as little as 2.5 volts of battery power.
Wall Clip
Wall
Clip Slot
Fig. 33— Remote/Transmitter
Wall Clip
Vent-Free Gas Fireplace User’s Manual
To Next Page
Loading...
