EasyManua.ls Logo

Hearth & Home HHFPDF32F1 - Remote Operation

Hearth & Home HHFPDF32F1
80 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
26
Remote Control Operation
This remote control system was developed to provide a convenient, user-friendly, and safe remote
control system for gas heating appliances. The system is operated manually from the remote/transmitter
and operates on radio frequencies (RF) within a 20-foot range using non-directional signals. The system
uses one of 16777216 security codes that are programmed into the remote/transmitter at the factory.
The remote receiver’s code must be matched to the transmitter’s code prior to initial use.
NOTE: Review COMMUNICATION SAFETY under the GENERAL INFORMATION section. This safety feature
shuts down the appliance during potentially hazardous or unsafe conditions.
This remote control system provides you with a battery-operated remote control to power the gas valve.
(see Fig. 25).
Using the battery power from the receiver, the solenoid circuit operates a solenoid. The circuit uses
reversing polarity software to reverse the positive (+) and negative (-) output of the receiver’s battery
power, which drives a latching solenoid ON/OFF. The system is controlled by the remote/transmitter, which
operates on two (2) 1.5 V AAA batteries.
Always use ALKALINE batteries for
longer battery life and maximum
performance. Do not use rechargeable
batteries. Before using the remote/
transmitter, place the two (2) AAA
batteries in the battery compartment.
Ensure the batteries are placed in the
proper direction.
Before using the remote/transmitter,
place the two (2) AAA batteries in the
battery compartment. Ensure the
batteries are placed in the proper
direction.
IF YOU CANNOT READ OR UNDERSTAND THESE INSTALLATION INSTRUCTIONS,
DO NOT ATTEMPT TO INSTALL OR OPERATE THIS DEVICE.
WARNING
Key Settings
ON Turns the heater ON. Manually operated solenoid ON.
OFF Turns the heater OFF. Manually operated solenoid OFF.
MODE Changes the heater from manual mode to thermostat mode.
>
Sets the temperature in thermostat mode.
Fig. 25—Remote/Transmitter
LCD
ON
BUTTON
OFF
BUTTON
MODE
BUTTON
UP
BUTTON
DOWN
BUTTON
BATTRY
COMPARTMENT
WALL CLIP
SLOT
>
Vent-Free Gas Fireplace User’s Manual

Related product manuals