5
Before beginning assembly or operation of this heater, ensure all parts are present. Check the parts against
the package contents list. If any part is missing or damaged, do not attempt to assemble, install, or operate
the heater. Contact customer service for replacement parts.
Estimated Assembly Time: 1-1/2 to 2-1/2 hours
Tools Required for Assembly (not included, unless otherwise stated):
Before installing the Fireplace Heater, ensure you have the following:
• Hardware package (included)
• Approved flexible gas hose if allowed by local codes
• Sealant (resistant to natural or propane/LP gas)
• Electric drill with 3/16" drill bit
• Phillips screwdriver
• External regulator (supplied by installer if required)
• Piping (check local codes)
•
Equipment shutoff valve
• Test gauge connection
• Sediment trap
• Tee joint
• Pipe wrench
•
3/8" NPT to 3/8" flare fitting
QUALIFIED INSTALLING AGENCY: Only a qualified agency should install and replace gas piping, gas
utilization equipment, or accessories, and/or repair and service such equipment. “Qualified agency” means
any entity that either in person or through a representative is engaged in and is responsible for:
• Installing, testing, or replacing gas piping; or
• Connecting, installing, testing, repairing, or servicing equipment; is experienced in such work; is familiar with
all precautions required; and has complied with all the requirements of the authority having jurisdiction.
Safety Information (cont.)
UNPACKING
1.
Remove Fireplace, Hood, Hardware packet and Fireplace Mantel
from the carton. Logs are packaged
inside fireplace.
2. Remove all protective packaging used on the Fireplace and Mantel.
3. Inspect the items for shipping damage. If you notice any damage, contact the dealer where the Fireplace
was purchased or contact Hearth & Home Dynamics, LLC at 1-888-xxx-xxxx.
Failure to position the parts in accordance with these diagrams or
failure to use only parts specifically approved with this heater may
result in property damage or personal injury.
WARNING
WARNING: This fireplace system is designed and safety certified for use with the mantel and
fireplace provided. Installing the fireplace without the provided mantel or substituting another
mantel will void the warranty and could result in property damage and personal injury.
NOTE: The fireplace is installed into the mantel through the front opening of the mantel cabinet.
To Next Page
Loading...
