Heat & Glo 8000CLX-IFT-S User Manual

1
Heat & Glo • 6000CLX-IFT, 8000CLX-IFT Owner’s Manual • 2506-981 Rev. K • 8/20
Models:
INSTALLER: Leave this manual with party responsible for use and operation.
OWNER: Retain this manual for future reference.
Contact your dealer with questions regarding installation, operation or service.
NOTICE: DO NOT discard this manual!
This appliance may be installed as an OEM
installation in manufactured home (USA
only) or mobile home and must be installed
in accordance with the manufacturer’s
instructions and the Manufactured Home
Construction and Safety Standard, Title 24
CFR, Part 3280 in the United States, or the
Standard for Installation in Mobile Homes,
CAN/CSA Z240 MH Series, in Canada.
This appliance is only for use with the type(s)
of gas indicated on the rating plate. This
appliance is not convertible for use with other
gases, unless a certied kit is used.
In the Commonwealth of Massachusetts installation must be
performed by a licensed plumber or gas tter.
See appliance installation manual for additional
Commonwealth of Massachusetts requirements.
• DO NOT store or use gasoline or other am-
mable vapors and liquids in the vicinity of this
or any other appliance.
• What to do if you smell gas
- DO NOT try to light any appliance.
- DO NOT touch any electrical switch. DO
NOT use any phone in your building.
- Leave the building immediately.
- Immediately call your gas supplier from
a neighbor’s phone. Follow the gas sup-
plier’s instructions.
- If you cannot reach your gas supplier, call
the re department.
• Installation and service must be performed
by a qualied installer, service agency, or the
gas supplier.
WARNING:
FIRE OR EXPLOSION HAZARD
Failure to follow safety warnings exactly
could result in serious injury, death, or
property damage.
Owner’s Manual
Care and Operation
6000CLX-IFT-S
6000CLX-IFTLP-S
6000CLX-IFT-G
6000CLX-IFTLP-G
6000CLX-IFT-TG
6000CLX-IFTLPTG
8000CLX-IFT-S
8000CLX-IFTLP-S
8000CLX-IFT-G
8000CLX-IFTLP-G
8000CLX-IFT-TG
8000CLX-IFTLPTG
DANGER
HOT GLASS WILL
CAUSE BURNS.
DO NOT TOUCH GLASS
UNTIL COOLED.
NEVER ALLOW CHILDREN
TO TOUCH GLASS.
A barrier designed to reduce the risk of
burns from the hot viewing glass is provided
with this appliance and must be installed for
the protection of children and other at-risk
individuals.

Heat & Glo 8000CLX-IFT-S Specifications

General

Type	Gas Fireplace
Fuel Type	Natural Gas or Liquid Propane
Vent Type	Direct Vent
Ignition System	IFT (Intelligent Fire Technology)
Glass Type	Ceramic Glass
Control Type	Remote Control
Ignition Type	Electronic
Warranty	Limited Lifetime
Dimensions	Varies by model
Venting	Direct Vent
Efficiency	Up to 70%
Log Set Material	Ceramic Fiber
BTU Input (NG)	40, 000 BTU
Heat Output	Up to 40, 000 BTU/hr

Summary

Owner's Manual Safety Information

Fire or Explosion Hazard Warnings

Critical safety guidelines to prevent fire or explosion hazards.

Hot Glass Burn Prevention

Instructions to prevent burns from hot glass surfaces.

Important Safety and Operating Information

General Appliance Safety Precautions

General safety guidelines for operating the appliance.

Clear Space and Combustible Clearance

Guidelines for maintaining safe clearances around the fireplace.

Lighting and Operation Instructions

Intermittent Pilot Ignition (IPI) Lighting

Step-by-step guide for lighting the appliance using IPI.

Gas Leak Detection and Response

Procedures to follow if gas is detected during lighting.

Appliance Break-In and Heat Management

Initial Appliance Break-In Procedure

Power Outage Operation with IntelliFire Touch

Operating Fireplace with Battery Backup

How to operate the fireplace during a power outage using battery backup.

IntelliFire Touch System Operation

IFT-ECM Control Module Selector Switch

Explanation of the IFT-ECM selector switch positions.

IntelliFire System Operation Safety

Safety warnings related to system operation and risk of explosion.

IntelliFire Remote Control Functions and Options

Remote Control Operating Functions

Overview of functions controlled by the remote.

Homeowner Maintenance Tasks

Qualified Service Technician Maintenance

Gasket Seal and Glass Assembly Inspection

Annual inspection of gasket seals and glass assembly.

Burner Ignition and Operation Servicing

Service Technician Maintenance Tasks

LED Assembly Replacement

Optional Black Glass Refractory Cleaning

Refractory, Grate, and Valve Assembly Removal

Refractory Panel Removal Procedures

Grate and Valve Assembly Removal

Burner Identification and Verification Procedures

Burner Assembly Identification

Frequently Asked Questions - Appliance Issues

Common Appliance Operation and Appearance FAQs

Frequently Asked Questions - IntelliFire Touch Controls

Remote Control Operation and Troubleshooting FAQs

Troubleshooting common symptoms with the remote control.

IntelliFire Touch System Troubleshooting

ECM LED Error Code Interpretation

Explanation of error codes indicated by ECM LED lights.

Pilot Ignition Failure Troubleshooting

Steps to diagnose and fix pilot ignition failures.

Advanced IntelliFire Touch Troubleshooting

Pilot and Main Burner Ignition Issues

Diagnosing problems with pilot and main burner ignition.

System Shutdown and Cycling Troubleshooting

Troubleshooting appliances that shut down or cycle unexpectedly.

Service Parts for 6000CLX-IFT

6000CLX-IFT Log Set Assembly Parts

Service Parts for 8000CLX-IFT

8000CLX-IFT Log Set Assembly Parts

Service Parts - Valve Assembly Components

#18 Valve Assembly Parts List

Service Parts - Additional Components and Kits

Other Fireplace Service Parts

Gas Conversion Kit Information