Heat & Glo SL-350TRS-D User Manual

Heat & Glo • SL-750TRS-IPI-E, SL-550TRS-IPI-E, SL-350TRS-D, SL-350TRS-IPI • 2120-900 Rev. D • 6/07 1
Models:
SL-750TRS-IPI-E
SL-550TRS-IPI-E
SL-350TRS-D
SL-350TRS-IPI
Owner’s Manual
Installation and Operation
• Do not store or use gasoline or other fl am-
mable vapors and liquids in the vicinity of
this or any other appliance.
• What to do if you smell gas
- Do not try to light any appliance
- Do not touch any electrical switch. Do not
use any phone in your building.
- Immediately call your gas supplier from a
neighbor’s phone. Follow the gas suppli-
er’s instructions.
- If you cannot reach your gas supplier, call
the fi re department.
• Installation and service must be performed
by a qualifi ed installer, service agency, or the
gas supplier.
WARNING: If the information in these
instructions is not followed exactly, a fi re
or explosion may result causing property
damage, personal injury, or death.
DO NOT DISCARD THIS MANUAL
CAUTION
This appliance may be installed as an OEM installation in
manufactured home (USA only) or mobile home and must be
installed in accordance with the manufacturer’s instructions and
the manufactured home construction and safety standard, Title
24 CFR, Part 3280 or Standard for Installation in Mobile Homes,
CAN/CSA Z240MH.
This appliance is only for use with the type(s) of gas indicated
on the rating plate.
Installation and service of this appliance should be
performed by qualifi ed personnel. Hearth & Home
Technologies suggests NFI certifi ed or factory trained
professionals, or technicians supervised by an NFI
certifi ed professional.
• Leave this manual with
party responsible for use
and operation.
DO NOT
DISCARD
WARNING
• Important operating
and maintenance
instructions included.
• Read, understand and follow
these instructions for safe
installation and operation.
In the Commonwealth of Massachusetts:
• installation must be performed by a licensed plumber
or gas fi tter;
See Table of Contents for location of additional
Commonwealth of Massachusetts requirements.
This appliance has been supplied with an integral barrier
to prevent direct contact with the fi xed glass panel. Do
NOT operate the appliance with the barrier removed.
Contact your dealer or Hearth & Home Technologies if the
barrier is not present or help is needed to properly install one.
HOT! DO NOT TOUCH.
SEVERE BURNS MAY RESULT.
CLOTHING IGNITION MAY RESULT.
• CAREFULLY SUPERVISE children in same room as
appliance.
• Alert children and adults to hazards of high temperatures.
• Do NOT operate with protective barriers open or
removed.
• Keep clothing, furniture, draperies and other combustibles
away.
Glass and other surfaces are hot during
operation and cool down.
• Keep children away.

Heat & Glo SL-350TRS-D Specifications

General

Type	Direct Vent Gas Fireplace
Style	Traditional
Vent Type	Direct Vent
Fuel Type	Natural Gas or Liquid Propane
Control Type	Remote Control
Log Set Material	Ceramic Fiber
Warranty	Limited Lifetime Warranty

Summary

Listing and Code Approvals

Requirements for the Commonwealth of Massachusetts

Specific installation requirements for Massachusetts.

Getting Started

Design and Installation Considerations

Key factors to consider before starting the installation process.

Inspect Appliance and Components

Instructions for checking the appliance and its parts for damage.

Framing and Clearances

Selecting Appliance Location

Guidance on choosing a suitable location for the appliance.

Clearances

Specifies required clearances around the appliance for safety.

Termination Locations

Vent Termination Minimum Clearances

Minimum clearances required for vent termination points.

Vent Clearances and Framing

Pipe Clearances to Combustibles

Specifies vent pipe clearances from combustible materials.

Wall Penetration Framing

Instructions for framing wall penetrations for vent pipes.

Appliance Preparation

Securing and Leveling the Appliance

Procedures for properly positioning and securing the appliance.

Installing Vent Pipe

Assembly of Vent Sections (DVP Pipe)

Instructions for assembling DVP vent pipe sections.

Assembly of Vent Sections (SL pipe)

Instructions for assembling SL vent pipe sections.

Gas Information

Gas Connection

Guidelines for safely connecting the gas supply line.

Electrical Information

Connecting to the Appliance

Instructions for connecting electrical power to the appliance.

Operating Instructions

Before Lighting Appliance

Pre-lighting checks and safety precautions.

Lighting Appliance

Step-by-step guide for lighting the appliance.

Troubleshooting

Standing Pilot Ignition System

Troubleshooting guide for standing pilot ignition issues.

Intellifire Ignition System

Troubleshooting guide for Intellifire ignition system issues.

Maintaining and Servicing Appliance

Maintenance Tasks

Recommended maintenance tasks for the appliance.