To Next PageTo Next Page
Need help?Do you have a question about the Heat & Glo SL-350TRS-C and is the answer not in the manual?
General| Style | Traditional |
|---|---|
| Efficiency | Up to 70% |
| Vent Type | Direct Vent |
| Glass Type | Ceramic Glass |
| Width | 35.5 inches |
| Warranty | Limited Lifetime Warranty |
| Type | Gas Fireplace |
| Fuel Type | Natural Gas or Liquid Propane |
| Ignition Type | Electronic |
| Venting | Top Vent |
Details about appliance certification and standards compliance.
Information on tempered glass specifications and safety standards.
Specifies the maximum and minimum BTU input for different models.
Guidelines for installing the appliance at higher elevations.
Defines materials considered non-combustible for safety.
Defines materials considered combustible for safety.
Specific requirements for installations in Massachusetts.
Key factors to consider before planning appliance installation.
Lists necessary tools and building supplies for installation.
Instructions for inspecting the appliance and its components for damage.
Guidance on choosing an appropriate location for the appliance.
Instructions for building a chase to enclose the appliance and vent system.
Specifies required clearances to combustibles and other surfaces.
Defines acceptable mantel projections above the appliance.
Details minimum clearances for vent termination points.
Explains symbols used in vent diagrams for pipe sections.
Guidelines on using 45° and 90° elbows in vent configurations.
Standards used for vent measurements in diagrams.
Instructions and requirements for supporting flexible vent sections.
Visual representations of vent configurations and limitations.
Specifies clearances required between vent pipes and combustible materials.
Details on framing holes for vent pipe wall penetrations.
Instructions for framing ceiling/floor penetrations and installing attic shields.
Steps for preparing the appliance for top venting installation.
Steps for preparing the appliance for rear venting installation.
Procedures for properly positioning, leveling, and securing the appliance.
Instructions for assembling DVP series vent pipe sections.
Guidance on cutting and assembling MI vent sections.
Instructions for assembling DVP-12A slip sections.
How to properly support vertical and horizontal vent sections.
Steps for safely disassembling DVP series vent sections.
Instructions for assembling SL series vent pipe sections.
Guidance on installing support brackets for horizontal and vertical runs.
Procedures for installing heat shields and horizontal caps for DVP pipe.
Procedures for installing wall shield firestops and horizontal caps for SL pipe.
Steps for installing roof flashing and vertical termination caps.
Information on converting between natural gas and propane fuels.
Specifies required inlet and manifold gas pressures for operation.
Instructions for making the gas supply line connection.
Guidance on selecting appropriate wire types for connections.
Instructions for wiring connections to the appliance.
Wiring diagram and notes for standing pilot ignition systems.
Wiring diagram for the Intellifire ignition system.
Steps for installing the electrical junction box.
Instructions for wiring a wall switch for the fan accessory.
Defines acceptable mantel projections above the appliance.
Guidelines for applying facing materials around the appliance.
Instructions for removing shipping materials from the appliance.
Steps for cleaning the appliance interior and control cavity.
Guidance on installing approved accessories.
Instructions for correctly placing ember and lava rock materials.
Steps for installing the fragile refractory panels.
Detailed instructions for placing the gas logs correctly.
Pre-operation checks and safety precautions for technicians.
Step-by-step instructions for lighting the appliance.
Information on initial burn-in procedures and condensation.
Common issues and their solutions during operation.
Troubleshooting guide for issues with the standing pilot ignition.
Troubleshooting guide for Intellifire ignition system problems.
Detailed checklist for inspection and maintenance of appliance components.
Diagrams showing appliance dimensions for different models.
Illustrations of various vent components and their specifications.
