Why is my Heat Controller Air Conditioner not cooling or heating effectively?
If your Heat Controller Air Conditioner isn't cooling or heating effectively, verify that the air filter is clean, adjust the temperature settings correctly, and ensure that the air inlet or outlet vents of the indoor unit are not obstructed.
What to do if the Heat Controller Air Conditioner remote display is faint?
If the Remote Controller display for your Heat Controller Air Conditioner is faint or has no display, check if the batteries are depleted or if they are inserted in the correct (+) and (-) directions.
What to do if my Heat Controller Air Conditioner is leaking condensation?
If condensation is leaking from your Heat Controller Air Conditioner, check that the drain hose is tightly connected and that the indoor unit is installed evenly.
Why does my Heat Controller Air Conditioner not operate for 3 minutes after turning on?
If your Heat Controller Air Conditioner does not operate for about 3 minutes after turning on, wait about 3 minutes for operation to begin. This delay protects the compressor from frequent on/off cycles.
What is the crack sound from my Heat Controller DMC24DB-1?
The crack sound heard from your Heat Controller Air Conditioner is generated by the expansion or constriction of the front panel due to temperature changes.
General| Refrigerant | R410A |
|---|---|
| Phase | 1 |
| Cooling Capacity | 24000 BTU |
| Heating Capacity | 24000 BTU |
| Heating Seasonal Performance Factor (HSPF) | 9.0 |
| Voltage | 208/230V |
To Next Page
