To Next PageTo Next Page
Need help?Do you have a question about the Heat-N-Glo RSW-41 and is the answer not in the manual?
General| Fuel Type | Natural Gas or Propane |
|---|---|
| Ignition System | Electronic Ignition |
| Vent Type | Direct Vent |
| Log Set Material | Ceramic Fiber |
| Burner Material | Stainless Steel |
| Type | Gas Fireplace |
| Control Type | Remote Control |
| Framing Dimensions | Varies by model |
| Venting | Direct Vent |
| Dimensions (H x W x D) | 34" x 41" x 16" |
General safety rules and warnings to follow before and during installation and use.
Fireplace tested and listed per UL127 & ULC-S610; check local codes.
Lists components of the Heat-N-Glo system and optional accessories.
Details fireplace components and optional accessories with catalog numbers and descriptions.
Lists and describes various chimney components available for the fireplace system.
Discusses suitable locations for the fireplace and necessary space considerations.
Provides instructions and dimensions for framing the fireplace opening.
Details clearances required for adjacent combustible side walls and decorative surrounds.
Explains how to use 15-deg or 30-deg offsets/returns to bypass obstructions.
Details minimum chimney height requirements above the roof line based on code.
Provides steps to determine the required chimney components for installation.
Instructions for placing the fireplace on a flat surface and securing it.
Details the placement of metal strips for hearth protection.
Guidance on leveling the fireplace and securing it to framing.
Instructions on how to connect chimney sections together for the flue system.
Details the installation of firestop spacers when the chimney penetrates a ceiling or floor.
Instructions for installing an insulation shield to prevent contact with insulation.
Emphasizes checking chimney section connections for proper engagement.
Details methods for securing chimney sections, offsets, and stabilizers.
Instructions for marking the roof penetration point for the chimney.
Guidance on cutting and framing the roof opening for the chimney.
Instructions for continuing chimney assembly through the roof opening.
Details installing roof flashing and termination caps for weatherproofing.
Instructions for installing the optional outside air kit for combustion.
Instructions for installing the chimney air kit, required for Canadian installations.
Guidance on finishing the fireplace enclosure, including clearances and materials.
Information on connecting gas logs or decorative gas appliances and required clearances.
Details the construction and requirements for hearth extensions to protect floors.
Instructions for placing and sealing the hearth extension and applying finishing material.
Specifies approved noncombustible materials for finishing the fireplace front.
Provides clearance requirements for combustible mantels and trim pieces.
Refers to system components for glass door installation instructions.
Discusses framing materials and factors for constructing a chase.
Guidance on constructing a chase top with minimum air space around the chimney.
Instructions for installing round and telescoping termination caps in chase installations.
Overview of fireplace use, supervision, and maintenance recommendations.
Explains the importance and function of the outside air kit for combustion.
Details the correct operation of the flue damper (must be fully open).
Provides guidelines for proper operation and use of glass doors.
Instructions on using the factory-installed integral grate for holding logs.
Details the use and importance of the firescreen for spark control.
Discusses types of firewood, seasoning, and moisture content for optimal performance.
Step-by-step guide on how to safely start a fire in the fireplace.
Discusses common draft issues and troubleshooting steps for proper fireplace operation.
Safe procedures for disposing of fireplace ashes in a metal container.
Information on creosote buildup, its risks, and the need for inspection.
Steps for cleaning the chimney to remove creosote buildup.
Specifies minimum clearance distances for combustible materials around the fireplace.
