Heathkit HA-14 - Troubleshooting Chart

Page 34
| HW.22, HW.22, HW.32
TRANSCEIVER
@@O@6s3
7@* 7@4 7*@+t OOOO,
Mic.
MIC.
TUNE,
FINAL,
®@
®o
os
GAIN: LEVEL BIAS SPKR EXT. ANT ALC
BN RELAY POWER
sf ly ee
TO IGNITION SWITCH 2 a PIN 12
a PIN Et
TO DC POWER SUPPLY
MODEL HP.-14
RG-58
|
(SEED
He
a
RE
Soe TNS | output
Ce a -
Ce Sra a
a a} RE °
§ = ¢ —— |
Cac) |
Figure 3
Figure 3 shows how to connect the Linear
Amplifier to the Heathkit HW-12, HW.22, and
HW..32 Transceivers, In order to use the
Linear Amplifier with these Transceivers, it is
necessary to slightly modify the Transceiver
for external ALC, If the Linear Amplifier is
used with a transceiver without ALC, wrap
+ insulating tape around the phono plug to pre.~
vent shorting, .
HW-12, HW-22, HW-32 Modification
NOTE: The Linear Amplifier has a built in
antenna relay, therefore, the RCVR jack on the
Transceiver is not needed, This jack will be
used for the external ALC output, Refer to
Figure 3A and the following instructions for this
modification,
( ) Mount the 1-lug terminal strip, supplied with
the Linear Amplifier, on one mounting screw
of the RCVR jack as shown,
Figure 3A