Heathkit HA-14 User Manual

Page
6
[essai]
HBATHEIT
8,
Then place the solder against the connection
and it will immediately flow over the joint;
use only enough solder to thoroughly wet the
junction, It is usually not necessary to fill
the entire hole in the terminal with solder,
Remove the solder and then the iron from
the completed joint, Use care not to move
the leads until the solder is solidified,
A poor or cold solder joint will usually look
crystalline and have a grainy texture, or the
solder will stand up in a blob and will not have
adhered to the joint, Such joints should be re-
heated until the solder flows smoothly. In
some cases, it may be necessary to add a
little more solder to achieve a smooth, bright
appearance,
ROSIN CORE SOLDER HAS BEEN SUPPLIED
WITH THIS KIT. THIS TYPE OF SOLDER
MUST BE USED FOR ALL SOLDERING IN
THIS KIT. ALL GUARANTEES ARE VOIDED
AND WE WILL NOT REPAIR OR SERVICE
EQUIPMENT IN WHICH ACID CORE SOLDER
OR PASTE FLUXES HAVE BEEN USED. IF
ADDITIONAL SOLDER IS NEEDED, BE SURE
TO PURCHASE ROSIN CORE (60:40 or 50:50
TIN. LEAD CONTENT) RADIO TYPE SOLDER.

Heathkit HA-14 Specifications

General

Brand	Heathkit
Model	HA-14
Category	Amplifier
Language	English