Heathkit SB-201 - Page 16

Ge queatTHuIT?
1/2" FIBER
FLAT WASHER
CREAR OF
CHASSIS
1/2" FIBER
FLAT WASHER
$3 Detail 2H
6-32 x 5/8" SCREW 3
(Y) Refer to Detail 2H and install the relay (#69-5)
at L. Use a 5/16” rubber grommet, three 1/2” fiber
| flat washers, and a 6-32 x 5/8” screw.
(
} Refer to Detail 2J and install a 100 kN control
(#10-12) at C. Use a contro] lockwasher and a
control nut. Position the control lugs as shown.
CONTROL
SOLDER LUG
CONTROL NUT
CONTROL LOCKWASHER
Detail 2J
Page 15
@ FRONT OF
th fo Lockwasner
VARIABLE
CAPACITOR
J, Detail 2K
(%)
Similarly, install the 1-wafer rotary switch
(#63-352) at B. Use a control solder lug and a
control nut. Position the switch lugs and solder
lug as shown in the inset drawing in Pictorial 2.
NOTE: Be sure to keep the plates of the variable
capacitors fully meshed (closed) at all times to pre-
vent damage during handling.
(+) Refer to Detail 2K and install the 850 pyf vari-
able capacitor (#26-160) on the top of the chas-
sis at D. Use #6 lockwashers, 6-32 nuts and two
#6 solder lugs at the locations shown.