Heathkit SB-201 - Page 36

Ge QHEATHKIT?
BEND LUGS
UP
(J Install the 572-B or T160-L tubes in tube sockets
V1 and V2.
( Ce an anode clip and RF choke combination
on the cap of each tube as shown in the inset
drawing in Pictorial 9.
( )~Connect the free choke lead of one of these
combinations to solder lug AP (NS). Position
the combination as shown.
( ) ‘ Connect the free choke lead of the other combi-
nation to solder lug AP (S-3). Position the com-
bination as shown.
( J Refer to Detail 9G and install the meter at AQ on
the front panel with a 3-lug terminal strip at AR.
Use a #6 lockwasher plus the lockwashers and
nuts supplied with the meter. Bend the lugs of
the meter upward, as shown.
a Remove the shorting clip from between the
meter lugs.
MaMa er eg te pie gal the EN ce es oer a, gy mn ce tong ee ge eee GEO ere ge Ae Be a re tS by REN Nee et Re Rb BEE ye aca Tee a NR toe ee
i : ens ‘ ; :
See ate i SURO heres :
Detail 9G
Page 35
FRONT
PANEL
METER
HARDWARE
| Connect a .02 yfd ceramic capacitor between
lugs 1 (NS) and 2 (NS) of meter AQ.
(.) Remove the control nuts from the two switches
and the control on the front of the chassis.
( ) Position the front panel in front of the chassis.
Connect the wires extending from hole H of the cir-
cuit board as follows:
(* ) Red to lug 2 of meter AQ (S-2).
‘i
Long
gray
to
lug
1
of
meter
AQ
(S-2).
( White to lug 1 of terminal strip AR (NS).
j
(“) Brown to lug 3 of terminal strip AR (NS).
()
Connect
the
white
lead
from
the
meter
pilot
lamp
socket
to
lug
1
of
terminal
strip
AR
(S-2).
()
Connect
the
black
lead
from
the
meter
pilot
lamp socket to lug 3 of terminal strip AR (S-2).