15 / 23
PL
SK
EN
CS
HU
• Spray thus diluted liquid spray at the already treated area. Do not empty! (Then do
a thorough rinsing).
• Store the agents for spraying locked away from children and animals.
• Empty containers of chemicals dispose of as hazardous waste (see the product
manufacturer‘s recommendations). Never put containers into the household waste.
• Sprayer is designed for outdoor use. In the case of inhalation of chemicals seek medical
advice immediately.
• In the case of penetration of spray into a closed room, thoroughly ventilate.
• The product must not be used by people under the influence of alcohol, drugs or other
intoxicating substances. In addition, the product must not be used by people with poor
physical condition, tired people, pregnant women, children and adolescents under 16 years
of age, and those who were not familiarized with these instructions.
• Never use a long-lasting or highly toxic chemicals for food, trees, shrubs and plants.
• Never use a sprayer near the source of food or drinking water.
• Never use special chemicals producing heat, pressure or gas.
• Never use sprayer when temperatures are lower than +5ºC and highter than +40ºC
• Never use liquids whose temperature exceed +40º C.
UNPACKING
• Carefully check all parts after unpacking the product from the box.
• Do not throw away packaging materials until you have not reviewed carefully if they did not
remain a part of the product.
• Parts of the packaging (plastic bags, paper clips, etc.) do not leave within reach of children,
could be a possible source of danger. There is a danger of swallowing or suffocating!
• If you notice transport damage or while unpacking, notify your supplier immediately. Do not
operate the product!
• We recommend save the package for future use. The packaging materials must still be
recycled or disposed of in compliance with the relevant legislation. Sort different parts of
the packaging according to material and hand it to the appropriate collection sites. For
further information contact your local administration.
C Fasteners can become loose during transport in the packaging.
PACKAGE CONTENTS
1x machine body, 1x spray rod, 3x spray head, 1x set of spare parts, 1x manual for use
• Standard accessories are subject to change without notice.
• This product requires assembly. The product must be assembled correctly before use.
ASSEMBLY
1. Unscrew the cap (fig. 3A) of the tank and remove the supplied accessories from the inlet filter.
2. Screw the union nut (fig. 4A) of the spray rod to the plastic trigger. Check tightness of all
connections.
3. Attach the carrying strap to the sprayer body using the clip (fig. 5A). If you are right-handed
the pump lever should be on the-left- hand side so that you can hold the spray lance right
hand.
4. Then assemble is finished.
To Next Page
Loading...
