EasyManua.ls Logo

hecht 54500 - Driver; Charger; Electrical Requirements

hecht 54500
27 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
13 / 27
PL
SK
EN
CS
HU
DRIVER
WARNING! B
MUST WEAR THE PROTECTIVE EQUIPMENT.
He must be careful and do not exceed his abilities. Driving beyond his limits
increases the risk of injury or damage.
He must keep his fingers and other body parts at a safe distance from the drive chain, gears,
wheels and all other moving parts.
Do not use headphones or mobile phones while driving.
Do not touch the brakes or engine on the ride on toy because they can be very hot during
use.
CHARGER
WARNING! B
Failure to follow the warnings and instructions may result in electric shock, fire and/
or serious injury.
CAUTION! A
The charger is not a toy.
Never pull the plug from the socket by pulling on the cord. Keep the supply cord away from
heat, grease and sharp edges.
Do not expose the charger to rain, snow or moisture. Water entering the charger increases
the risk of electric shock.
Make sure the cord is positioned so no one can step on it, trip over it or to prevent other
damage.
Never charge the battery in hazardous areas and near to combustibles, or in flammable
environments. Do not operate the charger on an easily flammable surface (e.g. paper,
textiles, etc.).
Do not place any objects on the charger that could block the air vents and cause excess heat
inside the charger. Place the charger away from heat sources.
Do not disassemble the charger. If it needs to be replaced or repaired, take it to an authorised
service centre. Unprofessional intervention can result in the risk of electric shock or fire.
NEVER store or use the charger in places where the temperature may reach or exceed 50 °C
(such as shelters, cars or metal buildings in summer).
If the procuct is not in use, it should be stored in a dry and secure place out of the reach of
children.
ELECTRICAL REQUIREMENTS
Never use at the nominal voltage other than 230V/50Hz. The circuit must be properly and
accordingly current protected.
Only connect to an electrical circuit that is protected by the current protector with actuating
current not exceeding 30 mA.