19 / 27
PL
SK
EN
CS
HU
• For full use of the machine, the battery must be replaced with a new one every
12 months.
CHAIN TENSION ADJUSTMENT
Check and lubricate the chain regularly to ensure its longest lifetime possible.
Adjust the chain tension as follows:
Remove the chain cover.
- Loosen the rear wheel axle nut.
- Loosen the rear brake caliper screw.
- Set the desired tension using the tensioner nuts. Pay attention, it must be the same on
both sides.
- Carefully tighten all loosened nuts and screws, check wheel alignment, and attach
the chain cover again.
BRAKE CABLE ADJUSTMENT
• To adjust the brake cable tension, screw the bowden end screw into/from the brake lever.
If the brake performance is still insufficient, it will be necessary to shorten the cable on the other
side. That is, right at the brake.
- Loosen the screw that secures the cable and pull at the cable so that it is not too tight.
- Tighten the screw again and gently adjust on the lever.
BRAKE PAD ADJUSTMENT
If the brake pads fit tightly to the brake disc, it is necessary to adjust them.
- Centre the pads so that the gap between the pads and the disc is the same everywhere
by loosening/tightening the socket heads.
BOOST PRESSURE FOR TYRES
Ensure correct tyre pressure. If the air pressure is too low, the tyre may become damaged or
slip off. Excessive tyre inflation may result in tearing of the tyre. The correct inflation pressure is
always provided on the side of the tyre.
Use a tyre inflator containing a pressure gauge to inflate the tyres.
To Next Page
Loading...