Hefter Systemform TF MEGA-M - Page 25

2-3
&KDSWHU%$6,&23(5$7,21
1-3. Operation Procedures
Power switch
1
Insert the power cord in the wall
socket and turn on the power.
Press “ I ” to turn on the power.
Press “O" to turn off the power.
Side guide
Fixing screw
Side guide
Fixing screw
2
/RRVHQWKH¿[LQJVFUHZVRIWKHVLGH
guides, and move the side guides to
¿WWKHSDSHUZLGWK
3
Raise the paper set lever and place
some paper on the paper feed table.
Push in the paper until its lead edge
touches the guide plate.
7KHPHVVDJH123$3(5GLVSOD\HGRQ
WKH/&'GLVDSSHDUVDQG&2817LV
displayed instead.
Fan the paper well and stack them
neatly at the center of the paper feed
table.
Side guide
Side guide
Fixing screw
Fixing screw
4
After pressing the side guide to each
side of the paper lightly, tighten the
screws to secure the side guides.
Paper can be stacked to a height of
approximately 45 mm at one time. Do
not stack too many sheets of paper.
Paper set lever
5
Lower the paper set lever.
The paper feed table will be raised.
Make sure that you lower the paper
set lever. If you start operations
without the paper set lever lowered,
the paper feed rings will run idle,
causing the machine to stop.
Paper
Paper set lever
Guide plate