Hefter Systemform TF MEGA-M - Page 27

2-5
&KDSWHU%$6,&23(5$7,21
Stacker roller
8
Move the stacker rollers to the
appropriate position referring to
the table of stacker rollers position
attached to the control panel section.
Use the table just as a reference.
<RXPD\QHHG¿QHDGMXVWPHQWV
according to various conditions
such as environmental conditions
(temperature, humidity), paper quality,
SDSHUWKLFNQHVVSDSHU¿EHUGLUHFWLRQ
cutting accuracy and printing
conditions.
 :KHQVWDFNLQJ$DQG%VL]HSDSHUZLWKORQJHGJHIHHGUHJDUGWKHSDSHUVL]HDV$DQG
 %UHVSHFWLYHO\)RUH[DPSOHLI\RXVWDFN$SDSHUZLWKORQJHGJHIHHGDQGIROGLWLQWRWZR
move the stacker rollers to "4."
9
Press the Start button for test
folding.
10
Press the Stop button after a couple
of folded sheets are ejected.
Test folded sample
11
 &KHFNWKH¿QLVKRIWHVWIROGLQJ
&KHFNIRUIROGLQJPLVDOLJQPHQWXVLQJWKH
second test folded sample.
If folding misalignments occur,
UHIHUWR&KDSWHU$'9$1&('
23(5$7,21³&RUUHFWLQJ)ROGLQJ
0LVDOLJQPHQW´

S