2
.0 Delivery of machine
• After receiving the machine please check:
- packing for damage (inform carrier immediately in case
o
f damage).
-
completeness of content according to delivery note.
-
examine the packing for sundry parts.
3.0 Operating instructions
Read the operating instructions precisely before
commissioning and use of the machine. No guarantee
is given in the case of incorrect handling and failure to
follow the operating instructions.
4.0 Proper use
-
The machine is designed solely to cut wood, plastics,
NF metal and soft iron using fretsaw blades and
marquetry saw blades with a length of 130 mm.
- Only cut workpieces which are securely supported
and can be guided.
- No further or different use is intended.
- The machine may only be used, fitted and maintained
by people familiar with it and aware of the risks.
- The relevant accident prevention regulations and other
generally acknowledged health and safety rules must be
observed.
- Only original spare parts may be used.
- The manufacturer is not liable for any damage caused
by use of non-original spare parts.
- Changes to the machine or incorrect use of the
machine exclude the manufacturer’s liability for
damage.
5.0 Safety notes
5.1 General safety notes
- Keep unauthorised persons away from the machine.
- Only allow children to work on the machine under
supervision.
- Do not touch any moving parts with fingers.
- Wear protective goggles.
3
5.2 Commissioning
- Check that the voltage on the motor rating plate
corresponds to the voltage from the power source.
- Connect the dust extractor.
⇒ Point 13.0
- Only work in ventilated areas.
5.3 Users
-
Read the operating instructions to prevent specific
machine accident risks.
- Never work under the influence of drugs, alcohol or
medication.
- Wear tight fitting clothing and protective goggles.
- Do not wear jewellery when working.
5.4 Before starting work
- Check that the machine is switched off.
⇒ Point 8.3
- Check that the saw blade fitted is suitable for the work.
- Check that the saw blade is clamped tightly.
- Check that all protective devices are fitted.
5.5 During work
- Remove residue and cuttings only when the machine is
switched off.
- On power failure, set the on / off switch to O.
5.6 After work
Switch off the machine and remove the plug.
6.0 Remaining risks
Even on proper use and despite observation of all
relevant safety regulations, because of the design
required for the purpose of the machine, the following
remaining risks can still arise.
- Touching the fretsaw blade.
- Breakage of fretsaw blade.
- Contact with live parts if there is damage to
- terminal box
- capacitor, or
- exposed supply cables.
- Inhalation of dust harmful to health.
To Next Page
Loading...