User-parameters
Up to 16 machine parameters can be made accessible to the machine operator via the MOD-function. These
user-parameters can be assigned by the machine tool builder at his own discretion.
Assignment of user-parameters
If a machine parameter is to be made accessible to the user, the lamp beneath the
0
p -key must be on
when programming the parameters (if necessary press
parameter is suffixed by the letter P.
0
p -key). After pressing the
El
ENT key, the
Machine parameter
Machine parameter with lowest parameter nurnber
Machine parameters allocated according to increasing parameter numbers
Example:
MP217 0 P
If one attempts to program more than 16 user parameters, the following error misssage is displayed:
TOO MANY USER PARAMETERS.
The following dialogue texts ar contained in the PLC-EPROM for the dialogue display of user parameters.
Dialog-display
USER PAR. 1
USER PAR. 2
USER PAR. 3
USER PAR. 4
USER PAR. 5
USER PAR. 6
USER PAR. 7
USER PAR. 8
USER PAR. 9
USER PAR. 10
USER PAR. 11
USER PAR. 12
USER PAR. 13
USER PAR. 14
USER PAR. 15
-
USER PAR. 16
Machine parameter with the highest parameter number
~__
Any dialogue text with a max. of 16 characters may be displayed instead of USER PAR. 1 etc. This requires
an amendment of the standard PLC-EPROM which can only be performed at the HEIDENHAIN factory in
Traunreut, West Germany. Please contact your local HEIDENHAIN-agency or our factory in Traunreut,
West Germany.
Please note:
The dialogue texts USER PAR. 1 to USER PAR. 16 are stored in the EPROM under the address of the PLC:
ERROR 84 to PLC: ERROR 99. If, however, error messages are required instead of dialogues, the corresponding
dialogue texts within the PLC-EPROM must be revised (Address of USER PAR. 1 = Address of PLC:
ERROR 99 etc.).
If special dialogues for user-parameters have been set within the customized PLC-program, the correlation
between texts and parameter Nos. is shifted if further user-parameters are inserted with the neutral designation
USER-PARAMETER.
39
To Next Page
Loading...
