Output of tool numbers
61
0 2
No output
1 *
=
Output only when tool
number changes
2 ,-.
=
Output of tool number
with every tool call
3 A
=
Output of tool store
number (if MP 225 - 1)
With parameter 61, the output of tool numbers or tool store numbers is programmed.
6.1.6 Machine parameters for output of tool numbers and tool store numbers
Function
Parameter
Possible
No.
entry values
Selected
entry values
Activation of the next
tool numbers
157
0 c
No output of next
tool number
1 A
=
Output only when next
tool number changes
2 A
=
Output of next tool
number with every
tool call
3 *
=
Output of next tool
store number with
TOOL DEF
(if MP 225” 1)
With parameter 157 it can be programmed as to whether the next tool number is output - or not - after output
of a tool number. Through cutput of the next tool number or next tool store number, a tool changing facility can
be brought into the required position.
Tool change position M92
X-ax is
Y-axis
Z-axis
I V-axis
186
187
188
189
- 30 000.000 . . . + 30 000.000 [mm]
With auxiliary function M92, tool change positions programmed in machine parameters 186 to 189 can be called-
up in relationship to the axis reference point.
Central tool memory
225 0 No central tool
memory
1 . . .
99
Central tool memory
with number of tool
store allocations
If parameter 225 is programmed with a value 2 1, a tool list with 1 to max. 99 tools - with or without special
tools - can be defined under program number 0 within the memory of the TNC 35l/TNC 155-control.
If an automatic toolchanger is being used, it can be set-up for fixed tool selection or random tool selection,
depending on the entry of parameters 61 and 157. Operation of a toolchanger is supported by a PLC-macro-
program (see separate description).
If parameter 225 is programmed with 0, a central tool memory is inaccessible and the output of tool store
numbers via parameters 61 and 157 is inhibited. The tools then have to be defined within the individual
workpiece programs.
48
To Next Page
Loading...
