HEIDENHAIN TNC 320 - Page 23

HEIDENHAIN Programming Station TNC 320/TNC 620/TNC 640 23
1.2 Compatibility
Touch probe cycles of NCK-based TNC 320, TNC 620 and TNC 640
controls
Meaning of the symbols used in the table:
– Parameter not available in this software version
þ Parameter or cycle available in this software version
x Cycle not available in this software version
Cycle Additional parameters TNC 320 TNC 620 TNC 640
340551 340560 340590
0, Reference plane – þþþ
1, Polar datum – þþþ
2, Calibrate TS – x x x
3, Measuring MB
REFERENCE SYSTEM
þ
þ
þ
þ
þ
þ
4, Measuring in 3-D – x x x
9, Calibrate TS length – x x x
400, Basic rotation Q305 þþþ
401, Rotation of 2 holes Q305
Q402
Q337
þ
þ
þ
þ
þ
þ
þ
þ
þ
402, Rotation of 2 studs Q305
Q402
Q337
þ
þ
þ
þ
þ
þ
þ
þ
þ
403, Rotation in rotary axis Q337
Q305
Q303
Q380
þ
þ
þ
þ
þ
þ
þ
þ
þ
þ
þ
þ
404, Set basic rotation – þþþ
405, Rotation in C axis – þþþ
408, Slot center reference point – þþþ
409, Ridge center reference point – þþþ