4-144 TNC 407/TNC 415/TNC 425 6 Display and operation 01.98
6.7 Cycles
The HEIDENHAIN contouring controls permit calling HEIDENHAIN standard-cycles within the NC
program (e.g.. pecking, tapping, pocket milling etc.). In addition, the manufacturer of the machine
can program manufacturer-cycles and store them in the control (see "OEM-cycles"). The sequence of
some cycles can be altered by machine parameters and PLC-markers. The description of the
"Tapping" and "Spindle-orientation" cycles can be found in the section "Main spindle".
6.7.1 Cycle inhibit
Machine parameter MP7245 can be used to selectively inhibit the HEIDENHAIN standard-cycles.
MP7245.0 Inhibit the HEIDENHAIN Cycles 1 to 15
Entry: 0 to 65 535
$0 to $FFFF
Bit 1 Cycle 1 0 = do not disable
Bit 2 Cycle 2 1 = disable
Bit 3 Cycle 3
Bit 4 Cycle 4
Bit 5 Cycle 5
Bit 6 Cycle 6
Bit 7 Cycle 7
Bit 8 Cycle 8
Bit 9 Cycle 9
Bit 10 Cycle 10
Bit 11 Cycle 11
Bit 12 Cycle 12
Bit 13 Cycle 13
Bit 14 Cycle 14
Bit 15 Cycle 15
To Next Page
Loading...
Need help?
General
