HEIDENHAIN TNC 640 - Page 104

Introduction | Status displays
2
104
HEIDENHAIN | TNC 640 | Conversational Programming User's Manual | 10/2017
Tool measurement (TT tab)
The control displays this tab only if the function is active
on your machine.
Soft key Meaning
No direct
selection
possible
Active tool
Measured values from tool measurement
Coordinate transformations (TRANS tab)
Soft key Meaning
Name of the active datum table
Active datum number (#), comment from the
active line of the active datum number (DOC)
from Cycle 7
Active datum shift (Cycle 7); the control
displays an active datum shift in up to 8 axes
Mirrored axes (Cycle 8)
Active rotation angle (Cycle 10)
Active scaling factor/factors (Cycle 11 / 26); the
control displays an active scaling factor in up to
6 axes
Scaling datum
In the optional machine parameter CfgDisplayCoordSys
(no. 127501) you can specify the coordinate system in
which the status display shows an active datum shift.
Further information: Cycle Programming User's Manual