Introduction | Status displays
2
HEIDENHAIN | TNC 640 | Conversational Programming User's Manual | 10/2017
105
Displaying Q parameters (QPARA tab)
Soft key Meaning
Display the current values of the defined Q
parameters
Display the character strings of the defined
string parameters
Press the Q PARAMETER LIST soft key. The control
opens a pop-up window. For each parameter type (Q,
QL, QR, QS) define the parameter numbers you wish to
control. Separate single Q parameters with a comma,
and connect sequential Q parameters with a hyphen,
e.g. 1,3,200-208. The input range per parameter type is
132 characters.
The display in the QPARA tab always contains eight
decimal places. The result of Q1 = COS 89.999 is
shown by the control as 0.00001745, for example.
Very large and very small values are displayed by
the control in exponential notation. The result of
Q1 = COS 89.999 * 0.001 is shown by the control as
+1.74532925e-08, whereby e-08 corresponds to the
factor of 10
-8
.
Global Program Settings (GS tab, option 44)
The control displays this tab only if the function is active
on your machine.
Soft key Meaning
No direct
selection
possible
Currently active values of the Global Program
Settings function:
Additive offset (M-CS)
Additive basic rotat. (W-CS)
Shift (W-CS)
Mirroring (W-CS)
Shift (mW-CS)
Rotation (WPL-CS)
Feed rate factor
Further information: "Global Program Settings
(option 44)", page 519
The values of the Handwheel superimp. setting are
displayed on the POS HR tab.
To Next Page
Loading...
