HEIDENHAIN TNC 640 - Page 692

Turning | Tools in turning mode (option 50)
16
692
HEIDENHAIN | TNC 640 | Conversational Programming User's Manual | 10/2017
Tool data for turning tool
Input parameters Use Input
ZL
Tool length (#1) Required
XL
Tool length (#2) Required
YL
Tool length (#3) Optional
DZL Wear compensation ZL
Optional
DXL Wear compensation XL
Optional
DYL Wear compensation YL
Optional
RS
Cutting radius Required
TO
Tool orientation Required
Angle of orienta-
tion
Orientation angle Required
T-ANGLE
Tool angle Required
P-ANGLE
Point angle Required
TYPE
Tool type Required
Tool data for recessing tools
Input parameters Use Input
ZL
Tool length (#1) Required
XL
Tool length (#2) Required
YL
Tool length (#3) Optional
DZL Wear compensation ZL
Optional
DXL Wear compensation XL
Optional
DYL Wear compensation YL
Optional
RS
Cutting radius Required
TO
Tool orientation Required
Angle of orienta-
tion
Orientation angle Required
CUTWIDTH
Width of the recessing
tool
Required
DCW
Oversize f. recessing tool
width
Optional
TYPE
Tool type Required