HEIDENHAIN TNC 640 - Page 693

Turning | Tools in turning mode (option 50)
16
HEIDENHAIN | TNC 640 | Conversational Programming User's Manual | 10/2017
693
Tool data for groove turning tools
Input parameters Use Input
ZL
Tool length (#1) Required
XL
Tool length (#2) Required
YL
Tool length (#3) Optional
DZL Wear compensation ZL
Optional
DXL Wear compensation XL
Optional
DYL Wear compensation YL
Optional
RS
Cutting radius Required
TO
Tool orientation Required
Angle of orienta-
tion
Orientation angle Required
CUTlengTH
Cutting length of recess-
ing tool
Required
CUTWIDTH
Width of the recessing
tool
Required
DCW
Oversize f. recessing tool
width
Optional
TYPE
Tool type Required
Tool data for button tools
Input parameters Use Input
ZL
Tool length (#1) Required
XL
Tool length (#2) Required
YL
Tool length (#3) Optional
DZL Wear compensation ZL
Optional
DXL Wear compensation XL
Optional
DYL Wear compensation YL
Optional
RS
Cutting radius Required
TO
Tool orientation Required
Angle of orienta-
tion
Orientation angle Required
T-ANGLE
Tool angle Required
P-ANGLE
Point angle Required
TYPE
Tool type Required