HEIDENHAIN TNC 640 - Page 694

Turning | Tools in turning mode (option 50)
16
694
HEIDENHAIN | TNC 640 | Conversational Programming User's Manual | 10/2017
Tool data for threading tools
Input parameters Use Input
ZL
Tool length (#1) Required
XL
Tool length (#2) Required
YL
Tool length (#3) Optional
DZL Wear compensation ZL
Optional
DXL Wear compensation XL
Optional
DYL Wear compensation YL
Optional
TO
Tool orientation Required
Angle of orienta-
tion
Orientation angle Required
T-ANGLE
Tool angle Required
P-ANGLE
Point angle Required
TYPE
Tool type Required