Manual Operation and Setup | Using a 3-D touch probe
17
750
HEIDENHAIN | TNC 640 | Conversational Programming User's Manual | 10/2017
Overview
The following touch probe cycles are available in the Manual
operation mode:
Refer to your machine manual.
The control must be specially prepared by the machine
tool builder for the use of a 3-D touch probe.
HEIDENHAIN only gives warranty for the function of the
probing cycles if HEIDENHAIN touch probes are used.
Soft key Function Page
Calibrating the 3-D Touch
Probe
758
Measuring a 3-D basic rotation
by probing a plane
769
Measuring a basic rotation
using a line
766
Setting the preset on any axis 773
Set a corner as preset 774
Set a circle center as preset 776
Setting the centerline as
preset
779
Touch probe system data
management
See Cycle Program-
ming User's Manual
To Next Page
Loading...
