HEIDENHAIN TNC 640 - Page 925

Tables and Overviews | Functions of the TNC 640 and the iTNC 530 compared
21
HEIDENHAIN | TNC 640 | Conversational Programming User's Manual | 10/2017
925
Cycle TNC 640 iTNC 530
205 UNIVERSAL PECKING
X X
206 TAPPING
X X
207 RIGID TAPPING
X X
208 BORE MILLING
X X
209 TAPPING W/ CHIP BRKG
X X
210 SLOT RECIP. PLNG (recommended: Cycle 253)
– X
211 CIRCULAR SLOT (recommended: Cycle 254)
– X
212 POCKET FINISHING (recommended: Cycle 251)
– X
213 STUD FINISHING (recommended: Cycle 256)
– X
214 C. POCKET FINISHING (recommended: Cycle 252)
– X
215 C. STUD FINISHING (recommended: Cycle 257)
– X
220 POLAR PATTERN
X X
221 CARTESIAN PATTERN
X X
225 ENGRAVING
X X
230 MULTIPASS MILLING (recommended: Cycle 233)
– X
231 RULED SURFACE
– X
232 FACE MILLING
X X
233 FACE MILLING
X –
239 ASCERTAIN THE LOAD
X, option 143 –
240 CENTERING
X X
241 SINGLE-LIP D.H.DRLNG
X X
247 PRESETTING
X X
251 RECTANGULAR POCKET
X X
252 CIRCULAR POCKET
X X
253 SLOT MILLING
X X
254 CIRCULAR SLOT
X X
256 RECTANGULAR STUD
X X
257 CIRCULAR STUD
X X
258 POLYGON STUD
X –
262 THREAD MILLING
X X
263 THREAD MLLNG/CNTSNKG
X X
264 THREAD DRILLNG/MLLNG
X X
265 HEL. THREAD DRLG/MLG
X X
267 OUTSIDE THREAD MLLNG
X X
270 CONTOUR TRAIN DATA for defining the behavior of Cycle 25
X X
275 TROCHOIDAL SLOT
X X
276 THREE-D CONT. TRAIN
X X
290 INTERPOLATION TURNING
– X, option 96