HeimVision Greets 1 - Advanced Settings; Basic Functions Configuration; Detection Alarm and SD Card; Cloud Storage and Device Version

To Next Page

To Previous Page

(serial number of your doorbell. It may be needed when the technical support is

required), etc

Basic Functions:

• Night Vision:

Turn on/off the night vision of the camera, or set it to automatic which mean the

doorbell will enable the night vision when it detects low-level ambient light. The

image will be black and white then.

• Speaker Volume:

Adjust the volume of doorbell’s speaker.

• Host leaves a Message:

Record voice messages

• Power Management:

Check the remaining power of your doorbell.

Detection Alarm:

Enable/disable Motion Detection, adjust the detection sensitivity and set schedules to

enable the motion detection.

SD Card:

Set the video length of each recording (only available for memory card), check the

remaining capacity of the memory card or format it.

Cloud storage service:

Tap to subscribe to, check, renew, and change the cloud plan, or enter the activation

code.

Device Version:

Check the version of the firmware.

Delete Device:

Tap to delete the doorbell permanently.

Leave a Voice Massage

This function helps you to quickly respond to visitors when it’s inconvenient to answer

the door. You can add 3 pre-recorded voice messages at most and the time length of

each message can last up to 10s.