16
Note:
• Press Up/Down/Left/Right to select and press OK to confirm.
• If OSD is ON, the date and time will be displayed on the status bar of the monitor;
otherwise, it will not be displayed.
Restore factory settings:
1. Select and confirm 2. Confirm YES to reset.
Press OK to enter the interface. Press or conform NO to exit.
Note:
If you restore the monitor to factory settings, the camera paired before may be deleted.
It’s required to pair the camera and monitor again for image streaming. Therefore,
please do it with caution.
Contact Us:
1. Select . 2. Scan the QR code or email us.
Press OK to enter the interface.
To Next Page
Loading...
Need help?
General