9
Step 3:
Place the camera at least 3ft/1m away from your baby.
Step 4:
Long press the Power button to turn on the monitor, then you can see the monitoring
interface.
Notes:
• The camera has been paired with the monitor already, just plug and use.
• If it shows you an icon after turning on the monitor, this is likely due to the far
distance between the monitor and camera, or the unsuccessful factory pairing.
Please move the monitor closer to the camera, or manually pair the monitor with
the camera following the next section accordingly.
CAMERA SETTING
Power on the camera and wait for about 1 minute, the camera will be ready for pairing.
Pair the camera
Step 1:
1. Press to enter the menu page.
2. Choose and press OK.
Step 2:
Select then press OK.
Tip:
A grey icon indicates that there is no camera.
Paired with this channel, while a green icon
indicates there is a camera paired with this
channel.
To Next Page
Loading...
Need help?
General