Note
When charging refrigerant into the system, make sure to charge in liquid state,
if the refrigerant of the appliance is R32.Otherwise, chemical composition of
refrigerant (R32) inside the system may change and thus affect performance of
the air conditioner.
According to the character of refrigerant (R32, the value of GWP is 675), the
pressure of the tube is very high, so be sure to be careful when you install and
repair the appliance.
If the supply cord is damaged, it must be replaced by the manufacturer, its
service agent or similarly qualified persons in order to avoid a hazard.
Installation of this product must be done by experienced service technician’s
professional installers only in accordance with this manual.
The temperature of refrigerant circuit will be high, please keep the
interconnection cable away from the copper tube.
Preset
Before using the air conditioner, be sure to check and preset the following.
Remote Control presetting
Each time after the remote control is replaced with new batteries or is energized,
remote control auto presetting heat pump. If the air conditioner you purchased is
a Cooling Only one, heat pump remote controller can also be used.
Back-light function of Remote Control (optional)
Hold down any button on remote control to activate the back light. It
automatically shuts off 10 seconds later.
Note: Back-light is an optional function.
Auto Restart Presetting
The air conditioner has an Auto-Restart function.
Safeguarding the environment
This appliance is made of recyclable or re-usable material. Scrapping must be
carried out in compliance with local waste disposal regulations. Before scrapping
it, make sure to cut off the mains cord so that the appliance cannot be re-used.
For more detailed information on handling and recycling this product, contact your
local authorities who deal with the separate collection of rubbish or the shop
where you bought the appliance.
To Next Page
Loading...
Need help?
General
