HOW TO USE
To operate the room air conditioner, aim the remote controller to the signal receptor.
The remote controller will operate the air conditioner at a distance of up to 7m when
pointing at signal receptor of indoor unit.
CAUTION!
For appropriate signal transmission between remote controller and indoor unit, keep
the signal receiver away from the following items:
• Direct sunlight or other strong lights or heat
• Flat panel television screen or other electrical appliances that react to the
remote controller
Additionally, the air conditioner will not operate if curtains, doors or other materials
block the signals from the remote controller to the indoor unit. If the signal may not
be transmitted properly, either move these materials or consult your local dealer.
OPERATION MODE
1. SELECTION MODE
Press button once by once
Result: the operation modes changed in sequence:
!Heating mode is NOT available for cooling only air conditioner.
2. FAN MODE
Press button once by once
Result: the fan speed is changed in sequence:
!At “FAN ONLY” mode, the “AUTO” is not available. At “DRY” mode, fan speed is set
as “AUTO” automatically, “AFN” button is ineffective in this case.
To Next Page
Loading...
Need help?
General
