Heinner HCD-V802B - Page 23

www.heinner.com 8kg, 220-240V~50Hz
13
PROBLEM
REASON
SOLUTION
The dryer cannot
be opened or the
programme
cannot be started.
The dryer does not
get activated when
adjusted.
The dryer might not be plugged in.
Make sure that the plug is fitted in the socket.
The loading door might be open.
Make sure that the loading door is properly closed.
You might not have set a programme or
pressed the Start/Pause key.
Make sure that the programme has been set and the
dryer is not in the Standby (Pause) mode.
Child lock might be active.
Deactivate the child lock.
The programe has
been interrupted
for no reason
The loading door might not be closed
properly.
Make sure that the loading door is properly closed.
There might have been a power failure.
Press the Start/Pause key to start the programme.
The water tank might be full.
Empty the water tank.
Clothes have
shrunk, felted or
deteriorated.
The programme used might not be
suitable for the type of laundry.
Check the care labels on the laundry items, select a
suitable programme for the type of laundry.
Water leaking
from the loading
door.
There might be lint accumulated on the
inner surfaces of the loading door and on
the surfaces of the gasket of the loading
door.
Clean the inner surfaces of the loading door and the
surfaces of the gasket of the loading door.
The loading door
opens on its own.
The loading door might not be closed
properly.
Push the loading door until you hear the closing sound
The water tank
warning symbol is
on/flashing.
The water tank might be full.
Empty the water tank.
The water discharge hose might be bent.
If the product is connected directly to the water outlet,
check the water discharge hose
The condenser
cleaning warning
symbol is on.
The condenser might be unclean.
Clean the condenser.
The filter cleaning
warning symbol is
on.
The lint filter might be unclean.
Clean the filter.
The filter seat might be clogged by lint.
Clean the filter seat.
There might be a layer that causes
obstruction on the surface of the lint
filter.
Wash the filter with lukewarm water.
The program can
not be started and
the filter warning
led is blinking
The filter seat might be clogged by lint.
Clean the filter seat.
There might be a layer that causes
obstruction on the surface of the lint
filter.
Wash the filter with lukewarm water.
The condenser may not be placed.
Replace the condenser.
The program can
not be started and
both condenser
and filter warning
leds are blinking
The condenser and filter may not be
placed.
Replace the filter and condenser.
The filter and condenser warning leds are
blinking even though the filter and
condenser are placed.
Call technical service.