EasyManua.ls Logo

Heinner HCD-V802B - Page 5

Heinner HCD-V802B
55 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
www.heinner.com 8kg, 220-240V~50Hz
4
Items with filling and damaged items (pillows or jackets). Foam protruding from these items
might catch fire during the drying process.
Operating the dryer in environments that contain flour or coal dust may cause explosion.
ATTENTION: Underwear that contains metal reinforcements should not be put in the dryer.
The dryer may be damaged if metal reinfoircements come loose ad break off during drying.
1.4. Correct Use
ATTENTION: Never stop a tumble dryer before the end of the drying cycle unless all items are
quickly removed and spread out so that the heat is dissipated.
ATTENTION: Make sure that pets do not enter the dryer. Check the inside of the dryer before
using it.
ATTENTION: Superheating of clothes inside of the dryer can occur if you cancel the
programme or in the event of a power failure whilst the dryer is running. This concentration
of heat can cause self-combustion so always activate the Refresh programme to cool down or
quickly remove all laundry from the dryer in order to hang them up and dissipate the heat.
Use the dryer only for household drying and to dry fabrics with a label that indicates they
are suitable for drying. All other uses are out of the scope of intended use and are prohibited.
The warranty will be void in case of any commercial use.
This appliance is designed to be used inside domestic residences only, and should be placed
on a straight and stable surface.
Do not lean against or sit on the door of the dryer. The dryer may tip over.
To maintain a temperature that will not harm the laundry (e.g. to prevent the laundry from
catching fire), a cooling process starts after the heating process. After this, the programme
ends. At the end of the programme, always remove the laundry promptly.
ATTENTION: Never use the dryer without a lint filter or with a damaged lint filter.
Lint filters must be cleaned after each use as indicated in Cleaning the Lint Filter.
Lint filters must be dried after wet cleaning. Wet filters might cause malfunction during the
drying process.
Lint accumulation must not to be allowed around the tumble dryer (not applicable for
appliances intended to be vented to the exterior of the building).
IMPORTANT: The clearance between the dryer and the floor should not be reduced with
objects such as carpets, wood or panel, otherwise, sufficient air intake cannot be ensured for
the machine.
Do not install the dryer in rooms where there is risk of freezing. Freezing temperatures
negatively affect the dryers performance.Condensation that freezes in the pump and hose
may cause damage.

Related product manuals