Fitting the machine undercounter
If you wish to fit your machine undercounter, check whether you have sufficient space
under your countertop and whether the wiring-plumbing is suitable to do so. 1 If you
decide that the space under the countertop is suitable for fitting your machine, remove the
worktop as shown in the illustration. 2
Warning: The stand part which we will settle our machine under it by removing its worktop
has to be stable in such a way not to allow balance disorder.
To remove the worktop, remove the screws that hold the worktop which are located at the
rear of the machine; then push the front panel 1 cm from the front side towards the rear
and lift it. Adjust the machine feet accprding to the slope of the floor(3)
Fit your machine by pushing it undercounter without letting the hoses get crushed or bent.
(4)
Warning: After removing the top panel of your dishwasher, the machine should be placed
in a space of the dimensions shown in the figure below.
To Next Page
Loading...
Need help?
General
