Why won't my Heinner HDW-FS6006DGE++ start?
If your Heinner Dishwasher won't start, check the following: ensure the plug is connected, check your indoor fuses, make sure the water inlet tap is turned on, verify that you've closed the machine door properly, be sure that you switched on the machine by pressing the Power On / Off button, and ensure that the water inlet filter and the machine filters are not clogged.
What to do if the Heinner HDW-FS6006DGE++ is not draining?
If your Heinner Dishwasher is not draining water, it could be due to a clogged water discharge hose or clogged filters. Check the water discharge hose and the filters to resolve this issue.
Why is water left in my Heinner HDW-FS6006DGE++ after the cycle?
If water remains inside your Heinner Dishwasher after the program ends, the water drain hose may be clogged or twisted, or the filters might be clogged. Check the water drain hose and the filters. Also, make sure that the programme is finished.
What to do if my Heinner HDW-FS6006DGE++ Dishwasher stops mid cycle?
If your Heinner Dishwasher stops mid-cycle, check for a power failure or a water inlet failure. The program may also be on standby mode.
Why are there white stains on dishes from my Heinner HDW-FS6006DGE++ Dishwasher?
If you notice whitish stains on your dishes after using the Heinner Dishwasher, it could be due to using too little detergent, a low rinse aid dosage, not using special salt with hard water, a low water softener setting, or a poorly closed salt compartment cap. Increase the detergent amount, increase the rinse aid dosage, use special salt, adjust the water softener system setting, and ensure the salt compartment cap is closed well.
How to fix inadequate water supply in Heinner HDW-FS6006DGE++?
If your Heinner Dishwasher is not getting enough water, ensure that the water input tap is fully open and there is no water cut. Also, close the water input tap, separate the water input hose from the tap, and clean the filter at the connection end of the hose. If the error persists, restart your machine and contact the service.
Why are the dishes not drying in my Heinner HDW-FS6006DGE++ Dishwasher?
If your Heinner Dishwasher is not drying dishes properly, it might be because you selected a program without a dry operation, the rinse aid dosage is set too low, or the dishes were unloaded too quickly. Select a program with a dry operation, increase the rinse aid dosage, and wait before unloading the dishes.
Why is my Heinner HDW-FS6006DGE++ making noise?
If your Heinner Dishwasher is making shaking and hitting noises during operation, it's likely due to dishes being placed incorrectly or the spray arm hitting the dishes. Rearrange the dishes and check the placement of the spray arm.
Why are there rust stains on dishes after using my Heinner Dishwasher?
If there are rust stains on the dishes washed in your Heinner Dishwasher, it could be due to insufficient stainless-steel quality of the dishes, a high rate of salt in the wash water, a salt compartment cap that is not closed well, too much salt spilt while filling, or unhealthy mains grounding. Use better quality dishes, reduce the amount of salt, ensure the salt compartment cap is closed well, clean up any spilled salt, and check the mains grounding.
Why is my Heinner HDW-FS6006DGE++ leaving food on dishes?
If your Heinner Dishwasher leaves food waste on the dishes, it could be due to incorrectly placed dishes, an overloaded basket, dishes leaning against each other, too little detergent, a weak wash program, a clogged spray arm, clogged filters, incorrectly fitted filters, or a clogged water drain pump. Rearrange the dishes, reduce the load, ensure dishes are placed separately, increase detergent amount, select a stronger program, clean the spray arm, check the filters, fit the filters correctly and check the water drain pump.
General| Category | Dishwasher |
|---|---|
| Capacity | 12 place settings |
| Energy efficiency class | E |
| Noise level | 49 dB |
| Number of programs | 6 |
| Height | 84.5 cm |
| Width | 60 cm |
| Control Type | Electronic |
Initial checks upon receiving the dishwasher and packaging disposal.
Critical points for safe installation, including placement and electrical connections.
Guidelines for safe daily operation, covering appliance usage and precautions.
Measures to protect children from potential hazards associated with the dishwasher.
Procedures for handling malfunctions and the importance of qualified repair personnel.
Advice on optimal usage for efficiency and dish care, including unsuitable items.
Guidance on environmentally responsible disposal and recycling of the appliance.
Guidance on selecting a suitable location and positioning the dishwasher correctly.
Instructions for connecting water inlet and outlet hoses, including pressure and safety.
Guidelines for safely connecting the dishwasher to an earthed electrical outlet.
Instructions for fitting the dishwasher under a countertop, including worktop removal.
Steps to prepare the dishwasher before its first operation, including salt and rinse aid.
How to determine water hardness and adjust the machine's setting using a test strip.
Guidance on selecting and adding detergent to the compartment for effective washing.
Information and advice on using 2-in-1, 3-in-1, or 5-in-1 detergent products.
How to fill the rinse aid compartment and adjust the dispenser level.
How to properly place dishes in the baskets for optimal washing and drying performance.
Description of adjustable dish racks and their usage for cups and glasses.
How to adjust the height of the upper basket to accommodate different dish sizes.
How to operate the control panel, select programs, and understand indicator lights.
Details on using Half Load, Extra Drying, Hygiene, and Extra Rinsing functions.
Instructions on how to change, set delay start, and cancel a program during operation.
Regular cleaning of the appliance, door seals, and addressing limescale buildup.
Step-by-step instructions for removing and cleaning the different filter types.
How to clean spray arms and safely maintain the drain pump.
Solutions for various problems like program start failure, overflow, noise, and dish quality.
Advice on unplugging, cleaning, loading, running, and placement considerations.
To Next Page
