Heinner HDW-BI6006A++

Questions and Answers

M
Melanie RoweAug 14, 2025
What to do if the Heinner HDW-BI6006A++ programme does not start?
- R
  robinsonrichardAug 14, 2025
  If the Heinner Dishwasher programme doesn't start, there might be several reasons: * The dishwasher isn't plugged in. Ensure the dishwasher is plugged in. * The dishwasher isn't switched on. Turn it on using the On/Off button. * A fuse might have blown. Check your indoor fuses. * The water inlet tap is closed. Open the water inlet tap. * The dishwasher door is open. Make sure to close the dishwasher door properly. * The water inlet hose and machine filters are clogged. Inspect and clear any clogs in the water inlet hose and machine filters.
C
Cameron HawkinsAug 21, 2025
What to do if water remains inside the Heinner HDW-BI6006A++?
- Q
  qmcguireAug 21, 2025
  If water remains inside the Heinner Dishwasher, it could be due to: * A clogged or twisted water drain hose. Inspect the drain hose, and either clean it or untwist it. * Clogged filters. Clean the filters. * The programme not being finished. Wait until the programme completes.
K
kimberlywatersAug 25, 2025
Why does my Heinner HDW-BI6006A++ have whitish stains remains on dishes?
- C
  Christopher CarlsonAug 25, 2025
  If whitish stains remain on dishes in your Heinner Dishwasher, it could be due to: * Not enough detergent used. Use the correct amount of detergent, as instructed in the programme table. * Rinse aid dosage and/or water softener setting set too low. Increase rinse aid and/or water softener level. * High water hardness level. Increase water softener level and add salt. * Salt compartment cap not closed properly. Check that the salt compartment cap is closed properly.
A
Angela ClarkAug 27, 2025
Why does the Heinner Dishwasher stop during washing?
- J
  John SmithAug 28, 2025
  The Heinner Dishwasher might stop during washing due to: * A power failure. Check the mains power. * A water inlet failure. Check the water tap.
J
James HallAug 31, 2025
How to fix rust stains on Heinner HDW-BI6006A++ Dishwasher dishes?
- J
  jodyjamesAug 31, 2025
  If rust stains form on the dishes in your Heinner Dishwasher, consider the following: * The stainless-steel quality of the dishes may be insufficient. Use only dishwasher-proof sets. * There may be a high level of salt in the wash water. Adjust the water hardness level using the water hardness table. * The salt compartment cap may not be closed properly. Check that the salt compartment cap is closed properly. * Too much salt may have spilled in the dishwasher while filling it. Use a funnel while filling the salt compartment to avoid spillage. * There may be a poor mains grounding. Consult a qualified electrician immediately.
R
Robert SullivanSep 3, 2025
How to stop shaking and hitting noises during a Heinner HDW-BI6006A++ wash?
- T
  Tiffany SilvaSep 3, 2025
  Shaking and hitting noises during a wash operation in your Heinner Dishwasher are likely caused by the spray arm hitting dishes in the lower basket. Move or remove items blocking the spray arm.
P
perryandreSep 6, 2025
Why don't dishes dry in my Heinner HDW-BI6006A++ Dishwasher?
- Y
  ymonroeSep 7, 2025
  If dishes do not dry in your Heinner Dishwasher, it could be because: * The drying option is not selected. Select a programme with a drying option. * The rinse aid dosage is set too low. Increase the rinse aid dosage setting.
E
Edward GreerSep 10, 2025
What to do if detergent remains in the detergent compartment of my Heinner HDW-BI6006A++?
- S
  Susan HendersonSep 12, 2025
  If detergent remains in the detergent compartment of your Heinner Dishwasher, it's likely because the detergent was added when the compartment was wet. Make sure the detergent compartment is dry before use.
B
Brittney CampbellNov 17, 2025
Why does my Heinner HDW-BI6006A++ Dishwasher have partial food wastes remain on the dishes?
- C
  Colleen MillerNov 17, 2025
  If partial food wastes remain on the dishes after a wash in your Heinner Dishwasher, consider the following: * Dishes may be placed incorrectly, preventing sprayed water from reaching them. Avoid overloading the baskets. * Dishes may be leaning against each other. Place dishes as instructed in the loading section of your dishwasher's manual. * Not enough detergent may have been used. Use the correct amount of detergent, as instructed in the programme table. * The wrong wash programme may have been selected. Use the information in the programme table to select the most appropriate programme. * Spray arms may be clogged with food waste. Clean the holes in the spray arms with thin objects. * Filters or the water drain pump may be clogged, or a filter may be misplaced. Check that ...

Summary

I. INTRODUCTION

II. CONTENT OF YOUR PACKAGE

III. SAFETY INSTRUCTIONS

General Safety Warnings

Covers general safety precautions for appliance use.

Installation Warnings

Details essential safety guidelines for machine installation.

During Usage

Outlines safe practices and restrictions during appliance operation.

Recycling and Environment

Information on recycling materials and environmental considerations.

IV. PRODUCT DESCRIPTION

Technical Specifications

Provides key technical details and specifications of the dishwasher.

V. INSTALLATION

Machine Positioning

Guidance on selecting an appropriate and safe location for the machine.

Water Connection

Instructions and warnings for connecting the water inlet and supply.

Drain Hose

Details on how to connect the water drain hose correctly.

Electrical Connection

Instructions for safe and proper electrical connection of the appliance.

VI. BEFORE USING THE APPLIANCE

Preparing for First Use

Steps to prepare the dishwasher before its initial operation.

Filling the Salt Compartment

Instructions on how to fill the salt compartment for water softening.

Test Strip Information

Information about a test strip for water hardness (not provided).

Water Softener and Detergent Management

Details on water softener settings and detergent usage/filling.

VII. LOADING YOUR DISHWASHER

Loading Guidelines and Recommendations

General advice for loading dishes for optimal washing results.

Basket Loading Examples

Illustrations of correct and incorrect ways to load baskets.

IX. CONTROL PANEL

Delaying a Programme

How to set a delayed start time for wash programmes.

Changing a Programme

Procedure for changing a programme while the machine is running.

Cancelling a Programme

Steps to cancel an ongoing wash programme.

Switching the Machine Off

Instructions on how to safely turn off the dishwasher.

X. CLEANING AND MAINTENANCE

Cleaning Dishwasher Interior

Methods for cleaning the inside of the dishwasher to prevent buildup.

Cleaning Filters and Spray Arms

Instructions for cleaning the machine's filters and spray arms.

VIII. TROUBLESHOOTING

IX. PRACTICAL INFORMATION

Machine Operation and Maintenance Tips

Practical advice for using and maintaining the dishwasher effectively.

Environment Friendly Disposal

Heinner HDW-BI6006A++ Specifications

General

Type	Built-in
Capacity	12 place settings
Energy efficiency class	A++
Number of programs	6
Noise level	49 dB
Control Type	Electronic
Display	Yes
Delay Timer	3/6/9 hours