Fitting the machine undercounter
If you wish to fit your machine undercounter, check whether you have sufficient space
under your countertop and whether the wiring-plumbing is suitable to do so. 1 If you
decide that the space under the countertop is suitable for fitting your machine, remove the
worktop as shown in the illustration. 2
Warning: The stand part which we will settle our machine under it by removing its worktop
has to be stable in such a way not to allow balance disorder.
To remove the worktop, remove the screws that hold the worktop which are located at the
rear of the machine; then push the front panel 1 cm from the front side towards the rear
and lift it. Adjust the machine feet accprding to the slope of the floor. 3 fit your machine by
pushing it undercounter without letting the hoses get crushed or bent. 4
Warning: after removal of worktop, the machine should be placed in such a closed place of
which dimensions are shown at fig.
To Next Page
Loading...
