Before using this washing machine, transport bolts must be removed from the backside of this machine. Please
take the following steps to remove the bolts:
1. Loosen all bolts with spanner and then remove them.
2. Stop the holes with transport hole plugs.
3. Keep the transport bolts properly for future use.
Before installing the washing machine, the location characterized as follows shall be selected:
-Rigid, dry, and level surface (if not level, please make it level with reference to the following figure “Adjust
Leg”).
- Avoid direct sunlight.
- Sufficient ventilation.
- Room temperature is above 0 °C.
- Keep far away from the heat resources such as coal or gas.
Make sure that the washing machine will not stand on power cord.
Do not install the washing machine on the carpet floor.
To Next Page
Loading...
