1. When positioning the washing machine, please first check if the legs are closely attached to the cabinet. If
not, please turn them to their original positions with hand or spanner and tighten the nuts with spanner.
2 . After positioning the washing machine, press four corners on top cover of washing machine in sequence.
If the washing machine is not stable when being pressed, this leg shall be adjusted.
3. Ensure the positioning status of washing machine. Loosen the lock nut with spanner and turn the leg with
hand until it closely contacts with the floor. Press the leg with one hand and fasten the nut closely to the
cabinet with the other hand .
4. After being locked properly, press four corners again to make sure that they has been adjusted properly. If
it is still unstable, it has to repeat Steps 2 and 3.
5. Put a solid cylinder (e.g. pop cans) oppositely on the top cover of the washing machine from in the left,
right, front and back directions. If the cylinder keeps stable, the washing machine is positioned level. If it
rolls, the washing machine is positioned unlevel. The rolling direction is the direction of lower ground
surface.Then, the two legs in this direction shall be raised at the same time until the washing machine is
level. Steps 1~3 are repeated to make the bottom legs closely against the ground and the nuts shall be
locked tightly.
Connect the inlet pipe as indicated in the figure. For the model which has hot valve , please connect the hot
vale to hot water tap. Energy will decrease automatically for some program.
To Next Page
Loading...
Need help?
General
