6 Data Management
Programmer PG 02 31
6 Data Management
The control provides various parameters for information on governor type, software version,
hardware version, etc.
6.1 Serial Number of Control Unit
Each individual control unit is unambiguously identified by a serial number. The first four
digits indicate year of production and month of delivery. The other digits represent the
serial production number. The serial number is to be found on the HEINZMANN type
plate or can be viewed by the following parameters:
3844 SerialDate Year and month of production
3845 SerialNumber Serial production number
6.2 Identification of Control
The application dependent functionality of a control is unambiguously defined by the
software running on exactly one definite type hardware.
3840 HardwareVersion Version number of control hardware
3841 AddHardwareVersion Version number of hardware modifications
3842 SoftwareVersion Version number of control software
3843 BootSoftwareVersion Version number of boot loading software
The software version identifier consists of a unique two to four digit customer number
defined by HEINZMANN, by a one to two digit variant number and by a two digit revision
index. DcDesk and the hand held programmers will permit the customer access only to
control devices including software of the specific customer number. The variants serve to
define different implementations, e.g., for different engines of a manufacturer or for
different applications of a certain type engine. Due to software extensions there can exist
different revision stages for the same variant with every higher ranking revision index
including the next lower one and replacing it completely.
To Next Page
Loading...
Need help?
General