Heinzmann Programmer 2 - Default Chapter; Table of Contents

To Next Page

To Previous Page

Contents

Programmer PG 02

Contents

Page

1 Safety Instructions and Related Symbols ........................................................................... 1

1.1 Basic Safety Measures for Normal Operation................................................................. 2

1.2 Basic Safety Measures for Servicing and Maintenance .................................................. 2

1.3 Before Putting an Installation into Service after Maintenance and Repair Works ......... 3

2 General ................................................................................................................................... 4

2.1 General System Description............................................................................................ 4

2.2 Further Informations........................................................................................................

2.3 Parameter Lists ................................................................................................................

2.4 Levels .............................................................................................................................. 8

3 Parameterization of HEINZMANN Speed Governors ...................................................... 9

3.1 Possibilities of Parameterization ..................................................................................... 9

3.2 Saving Data ................................................................................................................... 10

3.3 DcDesk 2000 ................................................................................................................. 10

3.4 Parameter Value Ranges................................................................................................ 11

3.5 Activation of Functions ................................................................................................. 12

3.6 Parameterization of Characteristics............................................................................... 12

3.7 Parameterization of Maps.............................................................................................. 13

3.8 Reset of Control Unit..................................................................................................... 14

4 Starting the Engine.............................................................................................................. 15

5 Configuring the Governor with the Hand Held Programmer ........................................ 20

5.1 The Display Panel..........................................................................................................

5.2 The Control Panel.......................................................................................................... 22

5.2.1 The Standard Functions ......................................................................................... 22

5.2.2 The Second Functions............................................................................................

5.2.3 Special Functions................................................................................................... 25

5.2.3.1 Engine Stop .................................................................................................... 25

5.2.3.2 Saving Values in the Governor ...................................................................... 25

5.2.3.3 Data Transfer Governor → Hand Held Programmer→ Governor ................ 26

5.2.3.4 Data TransferPC → Hand Held Programmerr → PC .................................... 27

5.2.3.5 Error Memory ................................................................................................ 27

5.2.3.6 Data Blocks .................................................................................................... 27

5.2.3.7 Automatic Adjustment of Actuator................................................................ 28

5.3 Parameter Selection.......................................................................................................

5.3.1 Entering Parameter Numbers.................................................................................

5.3.2 Selection by Arrow Keys....................................................................................... 28