Helite E-TURTLE - Installing the Fork Sensor on the Motorcycle

User Guide
22
A
A
B. INSTALLING THE FORK SENSOR ON THE MOTORCYCLE
1. Choose the right bracelet size.
Try the dierent sizes referring to the table
above. The right size has to be adjusted to
the motorcycle fork. The screw needs to be
screwed into the nut of the bracelet.
2. Assemble the sensor and the bracelet.
Clip the wide side of the bracelet to the side
of the fork sensor. Choose notch A to adjust the
bracelet to the size of your motorcycle fork.
3. Place the sensor.
a) Place the sensor on the bottom of one of the fork sleeves
of the motorcycle. Please check that no part of the motorcycle
comes into contact with the sensor while riding.
CAUTION If other vests are paired to the
sensor, they must be switched o.
Fork Shim Foam Notch Bracelet Screw size
35 mm
 
A 1 35 mm
≥ 37 mm
 
A 1 35 mm
≥ 40 mm
 
A 2 35 mm
≥ 44 mm
 
A 2 35 mm
≥ 48 mm
 
A 2 35 mm
≥ 50 mm
 
A 2 50 mm
≥ 53 mm
 
A 3 50 mm
CAUTION Make sure to thoroughly clean your fork
before installing the sensor.