21
User Guide
2. First use
AUTONOMOUS AIRBAG SYSTEM (WITHOUT FORK SENSOR):
1. Recharge your vest (see page 24).
2. Switch the vest on by quickly pressing the ON/OFF button 3 times. The LED ashes
green and you hear a beep.
3. You are ready to ride.
See page 26 for precautions before use.
OPTION WITH FORK SENSOR (SDU):
A. PAIR THE FORK SENSOR AND THE VEST
Before using your vest for the rst time, you need to pair (i.e. associate) the vest with
the fork sensor. To do so, you need your vest, the fork sensor and the magnet.
1. Switch on the vest by pressing three
times the button quickly. The LED ashes
green and you hear a beep.
2. Press the ON/OF button for 3 seconds
until the LED turns blue. Release the button
and go to the next step.
3. Place the magnet on the fork sensor
over the round slot. Please note that you
only have 30 seconds to eect this
procedure.
y If you hear a long beep: the vest and the
fork sensor are paired.
y If you hear a short beep: the fork sensor
has recognized the vest. The 2 sensors
have already been paired.
y If you hear several beeps (+ red LED):
the pairing has failed. Either you have
taken more than 30 seconds to place the
magnet over the sensor, or you already
have 5 fork sensors associated with the
vest. In the rst case, repeat the pairing
procedure. In the second case, you must
delete all the sensors associated with the
vest (see page 25).
CAUTION Check that the e-cartridge is properly screwed and connected to the vest.
x3
3sec
To Next Page
Loading...
