HELIX DSP PRO MK3 - Page 28

28
ACO platform features
Beside the unique DSP sound e󰀨ects the
DSP PRO MK3 provides a bunch of new system
and DSP features.
In the DCM menu of the DSP PC-Tool software in-
dividual settings can be made for several of these
system features.
Turn On & O󰀨 Delay
This function allows to determine the delay time
with which the DSP is switched on and o󰀨. The
factory setting is 0.2 seconds. The delay time
should only be modied if there are e.g. noises
while switching on / o󰀨 the signal processor.
URC Setup Switch Conguration
The ACO provides ten internal memory locations
for sound setups instead of the common two.
By using an optional URC remote control or the
Control pushbutton (see page 25) it is possible to
toggle between two of the ten memory locations.
These two memory locations can be determined
in the “URC Setup Switch Conguration”. The
memory locations one and two are preassigned
by default. To switch between all internal memory
locations, the optionally available remote controls
DIRECTOR and CONDUCTOR are recommended.
Remote Output Conguration
This function controls if the remote output (which
switches on and o󰀨 the connected ampliers) will
be temporarily deactivated during a sound setup
switch. This function is activated (ON) by default.
ADEP.3 Conguration
If the DSP PRO MK3 is connected to an OEM ra-
dio via the highlevel inputs it may happen that the
ADEP.3 circuit has to be adapted to the diagnostic
mode of the radio if the latter is equipped with a
so-called “class SB” output stage”.
In the “ADEP.3 SB compatibility mode & Advanced
Noise Suppression” section, an adjustment should
be made if there are e.g. distortions occur in the
upper volume range.
The compatibility mode is disabled by default.