Why is my HELLER HYAC15 Air Conditioner remote control not working?
If your HELLER Air Conditioner remote control isn't working, first, ensure you're close enough to the unit and aiming at the air outlet grille. If that doesn't work, try changing the batteries.
What to do if HELLER Air Conditioner does not seem to perform?
If your HELLER Air Conditioner isn't performing well, draw the curtains if the unit is in direct sunlight. Close any open windows or doors, and ensure there isn't a heat source in the room. Clean or change the air filter if it's dirty. Also, make sure that neither the air inlet nor the air outlet is blocked. Finally, check that the room temperature isn't lower than the set temperature.
What does P2 on HELLER Air Conditioner LCD mean?
If your HELLER Air Conditioner displays 'P2' on the LCD, it means the machine is full of water. You should drain the water from the drain port located at the bottom rear of the unit.
Why HELLER HYAC15 compressor doesn’t work?
If your HELLER Air Conditioner compressor isn't working, it might be due to heat-exceeded protection being active. Try restarting the unit after 4 minutes to allow the temperature to cool down.
What does E4 on HELLER HYAC15 Air Conditioner LCD mean?
If your HELLER Air Conditioner displays 'E4' on the LCD, it indicates anti-freezing protection is active. Wait for defrosting; the function will recover automatically.
General| Type | Portable Air Conditioner |
|---|---|
| Power Supply | 220-240V, 50Hz |
| Noise Level | 52 dB |
| Cooling Capacity | 15000 BTU |
| Power Consumption | 1500W |
To Next Page
